top of page
Tool Sharpening for Industrial
& General Manufacturing
Frank’s Industrial Sharpening regrinds end mills, drill bits, annular cutters and production CNC tooling to factory geometry for machine shops and manufacturing plants, so tooling budgets stretch further. Mail your tooling in from anywhere in the U.S., or use our route pickup and delivery across Florida and South Georgia.
What does Frank’s sharpen for machine shops and plants?
From round tooling to production cutters, these are the edges that keep spindles turning and tooling budgets under control.
End mills, drill bits, annular cutters, boring bits, and brad points
Precision-reground to factory geometry, with corner radii and point angles held to spec, so reground tools cut like new ones.
Production CNC tooling, carbide, spiral, and compression cutters are reground and ready to load, keeping your tool cribs stocked without constantly buying new.
Specialty cutters, form tools and one-off tooling from the plant floor. Not sure what you’ve got? Send a photo and we’ll tell you if we can sharpen it.
How many times can an end mill be reground?
A quality end mill can be reground several times before it's done; each regrind costs a fraction of the replacement cost, cutting to the same spec. The math is simple: shops that regrind spend less on tooling and scrap fewer parts to worn edges. We grind to manufacturer geometry, hold your tolerances, and turn tooling around fast enough to keep your crib stocked. Production shops can set up recurring pickup so dull tooling goes out and sharp tooling comes back on a schedule you don't have to think about.
Sharp Tooling, Shipped Nationwide
No matter where your shop runs, Frank's can sharpen your tooling. Fill out your information here and we'll ship you a box, put your tooling inside, ship it back with the prepaid label, and we sharpen and return it. Simple as that.
Get a Quote for Your Shop's Tooling
Tell us what you're running and we'll have a rep call you with pricing and turnaround.
bottom of page